Amplitude Modulation, AM Tutorial Includes:
Amplitude modulation, AM AM basic theory & formulas AM bandwidth & sidebands Modulation index & depth AM efficiency AM demodulation / detection Diode detector Synchronous detector AM modulators Single sideband, SSB SSB demodulation
Modulation formats: Modulation types & techniques Frequency modulation Phase modulation Quadrature amplitude modulation
亚博绑定银行卡有危险吗amplitude modulation or am as it is often called, is a form of modulation used for radio transmissions for broadcasting and two way radio communication applications.
亚博绑定银行卡有危险吗although one of the earliest used forms of modulation it is still used today, mainly for long, medium and short wave broadcasting and for some aeronautical point to point communications.
one of the key reasons for the use of amplitude modulation was its ease of use. the system simply required the carrier amplitude to be modulated, but more usefully the detector required in the receiver could be a simple diode based circuit. this meant that am radios did not need complicated demodulators and costs were reduced - a key requirement for widespread use of radio technology, especially in the early days of radio when ics were not available.
Amplitude modulation history
亚博绑定银行卡有危险吗the first amplitude modulated signal was transmitted in 1901 by a canadian engineer named reginald fessenden. he took a continuous spark transmission and placed a carbon microphone in the antenna lead.
亚博绑定银行卡有危险吗the sound waves impacting on the microphone varied its resistance and in turn this varied the intensity of the transmission. although very crude, signals were audible over a distance of a few hundred metres, although there was a rasping sound caused by the spark.
with the introduction of continuous sine wave signals, transmissions improved significantly, and am soon became the standard for voice transmissions. nowadays, amplitude modulation, am is used for audio broadcasting on the long medium and short wave bands, and for two way radio communication at vhf for aircraft.
however as there now are more efficient and convenient methods of modulating a signal, its use is declining, although it will still be very many years before it is no longer used.
Amplitude modulation applications
亚博绑定银行卡有危险吗amplitude modulation is used in a variety of applications. even though it is not as widely used as it was in previous years in its basic format it can nevertheless still be found.
- Broadcast transmissions: AM is still widely used for broadcasting on the long, medium and short wave bands. It is simple to demodulate and this means that radio receivers capable of demodulating amplitude modulation are cheap and simple to manufacture. Nevertheless many people are moving to high quality forms of transmission like frequency modulation, FM or digital transmissions.
- Air band radio: VHF transmissions for many airborne applications still use AM. . It is used for ground to air radio communications as well as two way radio links for ground staff as well.
- Single sideband: Amplitude modulation in the form of single sideband is still used for HF radio links. Using a lower bandwidth and providing more effective use of the transmitted power this form of modulation is still used for many point to point HF links.
- Quadrature amplitude modulation: AM is widely used for the transmission of data in everything from short range wireless links such as Wi-Fi to cellular telecommunications and much more. Effectively it is formed by having two carriers 90° out of phase.
these form some of the main uses of amplitude modulation. however in its basic form, this form of modulation is being used less as a result of its inefficient use of both spectrum and power.
What is amplitude modulation?
亚博绑定银行卡有危险吗in order that a radio signal can carry audio or other information for broadcasting or for two way radio communication, it must be modulated or changed in some way. although there are a number of ways in which a radio signal may be modulated, one of the easiest is to change its amplitude in line with variations of the sound.
亚博绑定银行卡有危险吗in this way the amplitude of the radio frequency signal varies in line with the instantaneous value of the intensity of the modulation. this means that the radio frequency signal has a representation of the sound wave superimposed in it.
in view of the way the basic signal "carries" the sound or modulation, the radio frequency signal is often termed the "carrier".
亚博绑定银行卡有危险吗from the diagram, it can be seen that the envelope of the signal follows the contours of the modulating signal.
amplitude modulation, am, is one of the most straightforward ways of modulating a radio signal or carrier. it can be achieved in a number of ways, but the simplest uses a single diode rectifier circuit.
亚博绑定银行卡有危险吗other methods of demodulating an am signal use synchronous techniques and provide much lower levels of distortion and improved reception where selective fading is present.
one of the main reasons for the popularity of amplitude modulation has been the simplicity of the demodulation. it enables costs to be kept low - a significant advantage in producing vast quantities of very low cost am radios.
Advantages & disadvantages of amplitude modulation, AM
亚博绑定银行卡有危险吗as with any technology there are advantages and disadvantages to be considered. the summary below gives a highlight of the basic pro's and con's.
- It is simple to implement
- it can be demodulated using a circuit consisting of very few components
- AM receivers are very cheap as no specialised components are needed.
- It is not efficient in terms of its power usage
- It is not efficient in terms of its use of bandwidth, requiring a bandwidth equal to twice that of the highest audio frequency
- It is prone to high levels of noise because most noise is amplitude based and obviously AM detectors are sensitive to it.
although in the current technological climate, am in its basic form is not nearly as effective as other modes that can be used, it is still retained in many areas like broadcasting, because of the number of users. however, it is likely that with time, its use will decrease still further and ultimately many am transmissions will cease. however, its derivatives like quadrature amplitude modulation are widely used as they offer a very effective form of modulation, espceially for data transmission.
Derivatives of Amplitude Modulation
亚博绑定银行卡有危险吗although the use of amplitude modulation is decreasing, it nevertheless forms the basis of other forms of modulation that are still being widely used, or their use is increasing.
- Single sideband, SSB: Single sideband is widely used for HF communications. It is formed by taking a signal that has the carrier and one sideband removed. In this way it becomes far more efficient in terms of both spectrum and power.
Read more about . . . . Single Sideband, SSB.
- Quadrature amplitude modulation, QAM: This form of modulation is essentially derived from two carriers that are 90° out of phase and adding information, either analogue or digital. Quadrature Amplitude Modulation is widely used for carrying many digital signals, everything from Wi-Fi to Mobile phone communications and very much more.
Read more about . . . . Quadrature amplitude modulation, QAM
am has advantages of simplicity, but it is not the most efficient mode to use, both in terms of the amount of space or spectrum it takes up, and the way in which it uses the power that is transmitted. this is the reason why it is not widely used these days both for broadcasting and for two way radio communication.
亚博绑定银行卡有危险吗even the long, medium and short wave broadcasts will ultimately change because of the fact that amplitude modulation, am, is subject to much higher levels of noise than are other modes.
for the moment, its simplicity, and its widespread usage, mean that it will be difficult to change quickly, and it will be in use for many years to come.
More Essential Radio Topics:
Radio Signals Modulation types & techniques Amplitude modulation Frequency modulation OFDM RF mixing Phase locked loops Frequency synthesizers Passive intermodulation RF attenuators RF filters Radio receiver types Superhet radio Receiver selectivity Receiver sensitivity Receiver strong signal handling
Return to Radio topics menu . . .