in the heyday of the crystal radio set there were many stockists supplying a wide variety of the different components and other parts needed to make or build one of these sets.
today, technology has moved on and the components for crystal radio sets are not as obvious, or they may be far more expensive.
fortunately it is till possible to make or build a crystal radio set without too much expenditure.
Crystal radio components
although a variety of circuits can be used for a crystal radio, the simplest form is shown in the diagram below. this uses just four components and serves to illustrate what component parts are needed.
obviously more complicated circuits can be used, but these have the added complexity of requiring more components.
亚博绑定银行卡有危险吗crystal radios require very few parts and these are summarised below:
- Coil or inductor: In the original crystal radios, this component could take a variety of forms. The coils were made on cylinders, on small formers or as a flat format where the wire was almost weaved on a flat circular shape with radiating slits cut in the base material so the wire could be wound on it and kept in place. Others coils formed the input matching transformer. Some were wound on two separate formers and there was a mechanical arrangement to alter the coupling between them.
For the home constructor, this component for the crystal radio can be made relatively easily. Typically it will need to be wound on a cylindrical former. Often card cylinders for wrapping paper or kitchen roll provide a useful and easy t use base that is easily available. Plastic pipe can also provide a good base as well. Other coils can be made from discarded transistor radios. Often these radios have ferrite rod antennas, which could form the basis of the coil. Although not in any way authentic, the circuit would work.
- Tuning capacitor: In the original crystal radios, this component could be in one of a variety of forms. Often these components had a series of vanes alternately connected to different connections of the capacitor. The vanes could be moved in and out, the degree of meshing altering the capacitance.
Today, it may be possible to obtain small plastic variable capacitors intended for use within AM transistor radios. The older metal and larger components are much more expensive these days.
- Signal diode: The original crystal detectors were the cat’s whisker style detectors described on another page. These consisted of a small piece of the rectifier material of crystal held in a holder onto which a thin piece of wire would be placed. This created a point contact diode an allowed the signal to be rectified and hence detected or demodulated.
Today small glass packaged germanium signal diodes like the e.g. OA47, OA90, OA91, IN34 etc. are often used. These diodes, rather than silicon diodes should be used because germanium diodes have a much lower turn on voltage, around 0.2V rather than the 0.6V of the silicon diodes. Schottky diodes an also be used as these have a low turn on voltage as well.
Both these types of diode are widely available for a few pence. They are much cheaper than many of the other components for the crystal set.
- Headphones: The headphones used must be high impedance versions. Originally high impedance moving coil headphones were used. Often these were based around the earpieces used in telephone handsets, and also the headsets were often quite uncomfortable.
Radio history timeline History of the radio Ham radio history Coherer Crystal radio Magnetic detector Spark transmitter Morse telegraph Valve / tube history Transistor Integrated circuit
Return to History menu . . .