亚博绑定银行卡有危险吗balanced antenna feeder is also know under several other names including twin feeder, and ribbon feeder. the term open wire feeder or open wire transmission line is often used to describe a particular form of balanced feeder consisting of two separate wires with spacers.
balanced feeder is a form of antenna feeder that can be used for feeding balanced antennas (i.e. antennas that do not have one connection taken to ground).
balanced feeder is mainly used on frequencies below 30 mhz, but in theory it can be used at any frequency.
as the name indicates, balanced feeder offers the advantage of being balanced, i.e. not having one side grounded. in addition to this it can provide a form of antenna feeder that provides low levels of loss, provided that it does not pass close to other objects.
balanced feeder is used less than coaxial feeder or coax, one of the main reasons for this is that it is affected by close objects and as a result it is not as convenient to use. it does not perform well if it is passed through a house in the same way that can be achieved with coaxial feeder.
Balanced feeder basics
a balanced or twin feeder consists of two parallel conductors unlike coax that consists of two concentric conductors.. the currents flowing in both wires run in opposite directions but are equal in magnitude. as a result the fields from them cancel out and no power is radiated or picked up. to ensure efficient operation the spacing of the conductors is normally kept to within about 0.01 wavelengths.
the feeder exists in a variety of forms. essentially it is just two wires that are closely spaced in terms of the radio frequency of operation. in practical terms manufactured feeder is available and it consist of two wires contained within a plastic sheath that is also used as a spacer between them to keep the spacing, and hence the impedance constant. another form commonly called open wire feeder simply consists of two wires kept apart by spacers that are present at regular intervals along the feeder. it has an appearance a little akin to a rope ladder.
Balanced feeder impedance
like coaxial cable, the impedance of twin feeder is governed by the dimensions of the conductors, their spacing and the dielectric constant of the material between them. the impedance can be calculated from the formula given below.
D is the distance between the two conductors
d is the outer diameter of the conductors
ε is the dielectric constant of the material between the two conductors
Types of balanced feeder
亚博绑定银行卡有危险吗this type of feeder can take a variety of forms. an "open wire" feeder can be made by having two wires running parallel to one another. spacers are used every fifteen to thirty centimetres to maintain the wire spacing. usually these are made from plastic or other insulating material. typically this feeder may have an impedance of around 600 ohms, although it is very dependent upon the wire, and the spacing used.
亚博绑定银行卡有危险吗the feeder may also be bought as flat 300 ohm ribbon feeder consisting of two wires spaced with a clear plastic. this is the most common form and is the type that is used for manufacturing temporary vhf fm antennas. if used outside this type absorbs water into the plastic dielectric. not only does this significantly increase the loss on damp days, but the moisture absorbed causes the wire to oxidise which in turn leads to increased losses over the longer term.
the feeder can also be bought with a black plastic dielectric with oval holes spaced at intervals in spacing. this type gives far better performance than the clear plastic varieties which absorb water if used outside.
More Antenna & Propagation Topics:
EM waves Radio propagation Ionospheric propagation Ground wave Meteor scatter Tropospheric propagation Cubical quad Dipole Discone Ferrite rod Log periodic antenna Parabolic reflector antenna Vertical antennas Yagi Antenna grounding Coax cable Waveguide VSWR MIMO
Return to Antennas & Propagation menu . . .